Profile Image

Auckland Integrity Waterproofing Limited

Waterproofing
Auckland
Write a review Share
About

We are Licensed Building Practitioners with over twenty years of construction waterproofing experience within the industry. Whether it is a large commercial project or a small residential job, every project is different, and we use that knowledge to deliver the highest standard and quality, so our clients end up with the right application solution.

We are an approved applicator for the major waterproofing system suppliers and we deal with the major building material suppliers. We are also an associate member of the Membrane Group (MGNZ).

What we do
Waterproofing
Areas served
Auckland, Franklin, Hauraki Islands, Manukau, North Shore, Papakura, Rodney, Waitakere, Waiheke Island
Business type
Company
Free quotes
Provided
Verification
Shield ID verified
Shield NZBN verified
Trade licences

Auckland Integrity Waterproofing Limited has not provided trade licence details. Not all work requires a licence. Before you engage with them for restricted work, ask them to provide supporting documentation.

Trade licence Registration Ownership Details
Licensed Building Practitioners - - -
Electrical Worker Register - - -
NZ Registered Architects - - -
Plumbers Gasfitters & Drainlayers - - -
Asbestos Assessor Licence Holder Register - - -
Asbestos Remover Licence Holder Register - - -
Chartered Professional Engineer - - -
Insurance

This tradesperson has not provided any public liability or professional indemnity insurance information. While this is not a legal requirement, if you engage them, ask if they hold any public liability or defective workmanship insurance.

Projects
Parkwood Apartments, George Street

600 square metres of Nuralite warm roof waterproofing at Parkwood Apartments, incorporating a double layer Nuraply 3PM membrane system installed over tapered PIR insulation and cover board. The warm roof system required careful planning, because of the size and complexity of the roof and the need to achieve the required falls while coordinating with the existing roof structure and building details. The job is a good illustration of why coordination between the waterproofing contractor, the engineer and the wider construction team matters. By resolving the build up and detailing questions as the work progressed, rather than leaving them to be discovered at the end, we were able to deliver a practical warm roof while maintaining the waterproofing performance the building needed. The tapered PIR insulation was installed to create the required falls, then the cover board went down to give the membrane a suitable substrate. - Tapered PIR set out to the falls the roof needed - Water directed towards the roof drainage points - Cover board over the insulation as the membrane substrate - Roof levels and perimeter heights checked against the structure Double Layer Nuraply 3PM A two layer Nuralite Nuraply 3PM system was then installed over the cover board, with every junction detailed by hand. - Two layers, for the redundancy a roof this size needs - Outlets and penetrations detailed individually - Upstands taken to height - Perimeter junctions worked through with the structure

Greenlane Kākāriki Hospital

Around 650 square metres of Viking Enviroclad TPO single layer membrane, installed in two parts so that the trades working underneath never had to stop. Splitting the work changed the sequencing for everyone, not just for us. The approach improved site productivity, sequencing and trade coordination, and it minimised delays while holding the quality and compliance standards the job required. Part one of the gutter goes in to let the roofing progress and keep the building protected from the weather. Part two is completed later, so other trades can carry on underneath while we safely finish the remaining gutter works.

Summerset St Johns

Approximately 2000 square metres of Rooflogic Fibertite Xtreme membrane to roof and internal gutter areas, delivered against a tight programme and a run of difficult weather. Fibertite Xtreme, Single Layer A single layer Fibertite membrane over cover board, taken across both the roof areas and the internal gutters. - Approximately 2000 square metres in total - Roof areas and internal gutters in one system - PIR and Stonewall insulation beneath - Cover board as the membrane substrate Shrink Wrap Where It Was Needed - Temporary shrink wrap areas let the crews keep installing while the weather was against the programme. - Work moved under cover rather than stopping - Protection from weather during installation - Productivity maintained through poor conditions - Programme deadline kept in sight

Manukau Superclinic

Derbigum to the roof plant decks and Fibertite to the internal gutters, with custom tapered insulation made to fix falls that had been ponding since the original design. Derbigum Xtreme, Double Layer - Around 370 square metres of double layer Derbigum over the roof plant deck areas, on acoustic board. - Double layer for the redundancy plant decks need - Laid over tapered and flat PIR insulation - Acoustic board as the substrate - Falls corrected in the insulation rather than the structure Fibertite Xtreme, Single Layer - Around 150 square metres of Fibertite to the internal gutters, where the detailing matters most. - Single layer Fibertite to the gutter runs - Outlets and penetrations detailed individually - Additional diverters to steer water to the outlets Laps kept clear of the water line

Verified work reviews
Spotlights
NEW to Builderscrack!

Auckland Integrity Waterproofing Limited has no review history as they are new to Builderscrack. Consider connecting — they might just be the right person for your job.

Learn More

Get connected now with NZ’s largest trade professional network

Get started

Partner with Builderscrack

Get work
Terms & Conditions | Privacy

© 2026 myQuote Limited, All Rights Reserved. "Builderscrack" and "BC" are registered trademarks of myQuote Limited. The connection process is protected by NZ patent #594581.

Partner site hipages.com.au