Review

Mains Pressure Hot Water Cylinder Connection

I require a 300 L Rheem outdoor mains pressure hot water cylinder connected. Cylinder is a Rheem Optima, 300 L, twin element, manufactured 2018, removed from a house mid 2019. Inlet valve and pressure relief vale are already fitted. I also have an Apex tempering valve and an unknown valve. Both pictured. House has original 1960 galvanised steel pipe, which appears to be in good condition. Main hot and cold water lines are immediately inside the wall behind the cylinder. Intend of fulling re-plumbing in the next 2 years. Old low pressure cylinder and header tank will need to be disconnected and drained, but left in place. I will arrange electrical connection. Would also like a plugged take off point or garden tap installed on the cold line to the new cylinder for a future garden hose supply. Under house access is via a internal cupboard, approximately 400 - 500 mm clearance, with a ground vapor barrier installed.

Review

Workmanship	5.0
Cost	4.0
Schedule	5.0
Communications	5.0

Work carried out by the owner/operator
Reviewed on 19-03-2020

Verified Builderscrack review

Job completed by

michael smit

Plumbing

Hurunui

4.6

As a licensed Craftsmen Plumber,for 30 years i am experienced in all general plumbing,new houses,alterations and specialize in repairs/maintenance.I can often provide a prompt same day service. I am also an experienced fruit tree pruner(specialize in home orchards),I also install irrigation for home orchards, and provide a consultancy service,where people wanting ideas and advice can visit my extensive home orchard, in Rangiora, or I can come to you.