Posted 1 week ago
Had an accident where a hole was punched into the pontoon at window height just below the deck. Need it repaired before the rain gets into our boat. Bulkhead damaged as well. (Not too much). Needs to have the 5mm plywood replaced ,fribreglassed ,primed and painted inside and out. Please quote. Not an insurance job.
Posted 2 months ago
My inboard motor needs some work done. Not sure what but has not been serviced for a couple of years. Please phone me late afternoon to arrange a time. Fraser ---
Few small holes to weld, and pits to fill
Wooden boat - remove area of rotten wood, replace with marine ply. Optional fiberglass and paint. Initial area is two cockpit seats; 0.5m x 2m. Easy access to top and bottom. Boating building experience required. Fiberglass experience preferred. Possible to continue further on other areas of deck once completed.
I have a 1987 Princess Redeemer Launch which is up for its annual insurance renewal and due to the age of the vessell the insurer is asking me to complete a condition report which must be prepared by anyone who habitually builds, works on or surveys boats. Can anyone help? Boat is based in Westhaven
2004 Yamaha 90 2 stroke, clea all 3 carburettors
I have a Hains hunter and the top gel coat is faded and has stress cracks and I’m wanting it repaird
Posted 3 months ago
Plastic kayak with hole from dragging
One of the bolts that holds the gunnels in place has come off and needs to be reattached. I can bring the boat to you. The gunnel and the bolt are stainless steel.
I need someone who knows a bit more than me. I can help. Both boats can be parked next to each other Cheers Neil.
Posted 4 months ago
Seems to be a corrosion issue. I can't get into the gear housing to apply CRC without vice grips, and thought it was time to call in an expert. Can anyone help me take off the gear lever and help get it un-stuck?
Need a mobile outboard motor expert to service outboard
Posted 5 months ago
Canoe has a few holes and cracks in the hull and ama piece that need to be patched up. Wanting a quote or weather it worth jist getting a new one
The old plywood deck has died and a new deck is needed. Open to options (ply, metal, other?). Most of the old deck is available so it can be traced.
Looking for someone skilled in SPLICING to complete 8x curtain ties (16 ends) using rope circa 2.5cm width.
Posted 6 months ago
My sand strip under boat is blend
Need pricing on recorking and painting 36ft woody bridge decker. Don't price if you have never done this before! For the price, assume no rot and seams do not require packing.
Posted 7 months ago
Hi guys I have aluminum boat with holes in the back. Needs welding hopefully. Need a rough price. I can bring the boat to you if it's easier.
Good morning. I have a 2101DC Striper and I need to replace bilge pump and washdown pump. I would be also interested to get a quote to rewire the entire boat as it is now 20 yo and needs a bit of tlc. The boat can be accessed mon-fri from 8am to 5pm as it is parked on a trailer at the office.
Replacement of the main windscreen of a Haines Hunter SR535
Posted 8 months ago
Tohatsu 9.8hp 2 stroke outboard needs service and possible repair. Has always run fine until last time being used it would start fine then would cut out going into gear. Last service unknown, probably well overdue. Need this done ASAP as we would like it in the water by Sunday. You do not need to be located in Newmarket- I am happy to drop off in most Central Auckland or North shore areas. Also have an inflatable takacat with a couple of slow air leaks in the tubes that need repairing - i...
Posted 9 months ago
Fix electrical connections or replace them. Some electronics working, some not.... need it fixed for spring
Posted 11 months ago
i know very well pipe fabrication, drowing,and install new project or repair project also know celling, wallpanel,door,window,galbalizing shit,insulation job etc.
Posted 1 year ago
Our small (2hp) yamaha outboard needs a service and has an issue with the pull cord. Model is - ---
check over, sea trial, oil lab tests, haul out at 11am 17/2/23
The deck on my boat has started to rot so needs to be replaced. Looking for options and quotes
Looking for certified outboard technician for outboard servicing
The Auckland Dragon Boat Assn require repair to the fiberglass hull of our dragonboat where there has been damage to the structure where a timber arm has been pulled off the boat and left a hole in the topside of two of our boats. The site of the hole will need replacing and strengthening, on 2 boats which are located under cover near Westhaven. The arm will need reattaching to the boat once repair completed. May also be additional work replacing gel cote and general touch ups to the...
Wire new tv, radio and other bits
We have an inflatable boat/tender and one of the seams has popped open, so it needs to be repaired. The boat is in Westhaven marina, so we are hoping someone could complete the repair as a mobile service.
Partner with Builderscrack