Posted 10 years ago
I need someone to install something I can lock my scooter onto while it's parked on the path - I have a retaining wall and thought a metal bolt and ring could be a good solution.
Currently lawn will need levelling 3.3 x 5m concrete to be laid
We require a stone / brick layer to complete a job that is approx 3/4 of the way through. The job is a stone wall about 10m in length and up to 1.4m high. There is only a portion of the wall left to finish and there are blasted rocks on site ready to go. Also there is an amount of additional concrete work.
Approx. 15m2 and up to 2m3 of concrete required. Intent to place approx. 50mm of exposed aggregate on top of existing pavers.
60m of continuous kerb along an existing driveway fence line. See picture. (Weeds have now been removed) Aim is to stop ingress of neighbours garden material onto driveway so needs to be approx. 150mm high and no more than 150mm wide. Continuous kerbing machine required.
Re Concrete trench in Driveway
A 3m x 6m reinforced concrete pad for a spa pool. The area is dug out and levelled and now needs someone with concrete mixer etc to box up and finish. I can provide additional manpower if needed.
Prep a small driveway, Approx 36m2 Box and lay concrete. Create fall etc. Dig holes for 18 deck posts and concrete
Wish to obtain a quote to replace split concrete patio caused by last earthquake in Wellington. This is up three levels with limited access. The attached photos will give you an idea of job. Sorry do not sure of measurements.
I have a concrete drive way that needs to be replaced, the job would involve breaking up the concrete and removing, and relaying a new driveway, would probably need some type of edge built
Hi, We have a pathway project going on, the concrete is going to be layed next week, we required help to apply stamps to create a pattern on concrete.
coloured and imprinted drive is showing some signs of wear and wondered if it could be resealed or something to improve the look
The exterior concrete plaster of the building is flaking off and falling, and some of the structural steel under it is exposed and has rusted. It is needed to treat the rusted steel and re-plaster the damaged plaster.
Posted 11 years ago
8-10 sqm approx
Hi There. We are building a house in the next few months and are looking for prices for a new driveway. The area we are looking is 120m2, completely flat with easy flat access. We are after plain concrete with decrative cuts. Location is Churton Park and are happy to meet you at the site if required
Existing tiles to be removed. Steps need to be extended i.e. widened so that they are the same width all the way down. One area of the path would be widened & the path extended over to the side of the house - some concrete needs to be broken out here. Box round some air vents. A top coat of 70mm of new concrete applied to the old path.
For floor in 1 bay of a 3 bay shed, 3.6m x 3.6m
Hi I need some kerbing boxed and layed, about 8 meters to control water runoff, and fence repair which runs along side this kerbing
Hi I have an area of approx 68 square meters and 18 posts to concrete in. Area has been preped and boxed. Can be done anytime from now. After a option for exposed as well. Viewing Fraser Ave, Johnsonville Cheers Stu
I have got concrete blocks in the garage, its not smooth its like chipseal and not even. Would like to get this sealed with the smooth finish like a floorings in the pak n save.
I have appromately 50 steps on my bank which presently have tiles. I will remove the tiles and flatten to a depth of 50 or so mm. The steps are more or less already boxed. I would like someone to concrete the steps and apply a pebble finish.
As per the attatched photos we are looking to have the paving lifted and re-compacted as in a few places we have had movement and spreading and dropping. Veiwing is advised for quote as there are areas that are fine and will just need re-grouting.
Need concrete job, 2 car carpad. Need to break up and remove existing concrete and re lay with cheapest option. please inspect to quote, in hataitai
Require concrete pad to be laid that is approx 4M x 4M
We need a new path from the footpath to our front gate. The measurements are approximately 4.7 metres long by 1.05 metres wide. Ideally the edging of the path should be a wooden like the neighbours have already done on one side of where the path will be but we are open to suggestions. We also want a mowing strip in front of the front fence.
Need a new concrete block wall plastered with a tidy clean finish with a texture/pattern if possible. Wall approx 6 mtr long and approx 1.2 high. As soon as possible. Thanks
install vehicle access (6 metre drop kerb) on to existing car pad. Already have council permit.
I am building a new house in Newtown. The house it on a vacant lot that does not have a vehicle access yet. I need a road crossign constructed and council pathway reinstated per council requirements.
Hi, I am looking for a contractor to put in a new driveway. The measurements will be 10m X 2.5m. Thanks
this is a long shot but ive got 1x outdoor fireplace I need assistance with to lift and morter and level the 10 components to create a finished BBQ/fireplace. all my friends are useless IT geeks with no mussles which makes lifting a little tricky! Id say it would be less then a hours worth as ill have all the bits ready to assemble! should be ready to go mid next week. Photo of is what the unit looks like. I have made a concrete pad (which is level) for it to sit on, If your intrested please...
Partner with Builderscrack