Review

Replace Galv Tee into HWC

Job image

Job description

New Home Plumbing
Invercargill

I have an electrolytically rusted galv tee riser into my HWC needing replaced I reinforced it with plastic steel as a short term measure a few years ago. I need my galv pipe cut, 2 compression fittings or similar and a new tee installed. I will assist with the work as the HWC gate valve is inside and behind a panel which has my fridge in front so I need to sort that. I can drain system prior to work being done to save time but I need to be there when it's done. I could do this myself but am short of time. Location is about 30cm inside outer wall and access is open from side of house as I have removed all the sidings to install plastic and batts.


Get connected now with NZ’s largest trade professional network

Get started

As seen on

logo
logo
logo
logo
logo
logo
logo
logo