Active job

Gypsum board installer

Studied blueprints.specification sheets and drawing to determine styleand type window or wall panel required .filled cracks.seam depression.and nailed hole with felter.examined wood surface for defects.such as nick.cracks or blister.measure cut materials to determined conformance to specifacation using tape measure .realigned window and screen to fit casements and oils moving part .measure and marked location of stads leaders and receptacle openings .using tape measure and marker.cut siding ang moldings section of weatherboard.openings and sheetrock and lumber .using hands tools.and power tolls.laid out and aligned materials on work table or in assembly jig acording to specified instruction..remove surface defects using knife scraper .wet sponge electric iron.and installed pre fabracated windows and doors.insulation wall ceiling and floor. Aligned and fastened materials together using hands tools and power tools to form buildings or bracing .repaired or replaced. Defective locks hinges cranks. And pieces of woods using glue hands tools and power tools. Applied stain.paint or crayons to defect and felter to touch up the repairs areas.