Review

Electrical work for install of external hot water cylinder

Hi I am planning to replace my bottled gas water heating system with a heat-pump based electrical hot water cylinder. This would be installed externally and replace the existing gas unit. My plumber/gasfitter has advised me to consult an electrician as it's likely we will need to run a new dedicated power supply from the switch board to the hot water cylinder. (There's an existing circuit to the gas heater unit but may not be specced correctly for a hot water cylinder) Model to be installed is a Stiebel Eltron 302L: --- This model has primary heat pump and a traditional electrical element as backup heating. Photos of the install location and switchboard included.

Full workmanship review

Workmanship	5.0
Cost	5.0
Schedule	5.0
Communications	5.0

"Professional work, took extra efforts to square everything away nicely."

Review posted by Murray on 7th November 2024

Verified Builderscrack review

Job completed by

Dr Watts Electrical Services Ltd

Electrical Auckland

5.0

At Dr Watts Electrical Services, our reputation means a lot to us. We believe that open communication is the most important part of completing any job and maintaining a healthy customer relationship. We aim to provide a professional, stress free service every time and always make sure our clients are 100% satisfied with our work before we leave. As registered electricians, we will provide you with the relevant safety/compliance certificates after any electrical work is completed. We’re fully