Review
Spa Plug Install
Job description
Published: 27 September 2023
We need a Spa plug installed for the Alpine Spa Vermont Model. Hoping to gauge price to do it as we set up the site. Electrical Requirements outlined below and in screen grabs. Spa plugs into a 15amp RCD protected outdoor socket, pre-attached cable length is 4.5m, the plug may look like your standard household plug, it is NOT. The bottom earth pin is larger and will only fit into a 15amp socket, see attached photo. You can hardwire at 25amps if you want the heater and the jets to operate at the same time. Wiring will need to run from switchboard inside, through roof and down the side of the house, under the deck to reach the site. Don't think we need to conduit under the concrete as we'll eventually build a deck over it.
Review
| Workmanship |
3.0
|
| Cost |
4.0
|
| Schedule |
4.0
|
| Communications |
5.0
|
Jordan was great, explained everything and had great timely communication. Unfortunately the team that did the job didn’t communicate as well so a switch needed to be moved after the install. All worked out in the end.
Work carried out by an employee of the company
Reviewed on 08-01-2024
Tradesperson reply
"Really appreciate your honest review Melinda
Great to hear our initial communications were good.
Apologies that the initial installation required modification - it's not often we get things wrong so we're thoroughly investigating what happened in order to prevent it from occurring again
Again, thank you for bringing it to our attention
Glad it worked out for you in the end
Regards, the team at The Conduction Company Ltd."
