We are looking to replace our existing recessed lights with Teda Urban LED lights. We have 65 lights in total that require replacement. Please note all 65 lights have already been purchased. Of these, 47 have the correct 10cm cutout and the wiring from the existing light could be used (see light A images). There is then 17 lights which are slightly smaller and require the cutout to be widened from 8cm to 10cm. I’m not sure the current wiring for these will be appropriate (see light B images). There is then 1 new cutout to be performed and 4 existing lights (3 of the light A and one of the light B) need to be decommissioned. The wiring to the Light B light to be decommissioned is less than a metre from where the new cutout and light is to go so could be extended for this new light. We wish to have 2 new pendant lights installed. There is a picture of one we have purchased for over the dining table and the second one is yet to be purchased but we thought it could be wired in preparation for its purchase. Finally, we have two small power point jobs. One keeps tripping the safety switch so want that looked into. The second is a new double power point to be installed in the garage. There is an existing power point directly through the wall in the laundry where the existing wiring could be used.
#1 | Tradie 1 |
|
57 jobs | No longer in contact |
#2 | Tradie 2 |
|
49 jobs | No longer in contact |
#3 | Tradie 3 |
|
14 jobs | No longer in contact |
#4 | Tradie 4 |
|
12 jobs | No longer in contact |
#5 | Tradie 5 |
|
9 jobs | No longer in contact |
#6 | Tradie 6 |
|
189 jobs | No longer in contact |
#7 | Tradie 7 |
|
1098 jobs | No longer in contact |
#8 | Tradie 8 |
|
66 jobs | No longer in contact |
Partner with Builderscrack
Get work