Review

Repair front door stair and tiles

Message 29th January --- am Please quote on the following modification The new surface will be slanted. The current tiled step at tiled surface is to drop 25mm (Min 20mm) relative to the tiled surface at the door. The current bearing structure is uniformly 50mm under the tiled surface. Mark the stair where the new surface should be lowered to. This is to provide water flow to the stair. Repair broken wooden structure as far as possible. Strengthen support by adding new cross beam connections. The client has H rated wood that can be used for this. Remove broken tile surface and MDF support. Install and apply suitable multi plywood surface (7 ply at least) to the bearing structure. The surface and sides of the plied wood should be covered with 2 layers of epoxy paint to ensure water proofing. The tiled dimensions are approximately 1.56 m in width and 0.79m short length -Left and 0.89m long length -Right -door to stair. See attached photos. The top should be finished with a non- slip tiled surface. The edge tiles at step should fit and match the other tiles in width, so that common grouting gaps can be implemented, to help water flow off the surface. (Colour and edging tiles to be recommended by client) The grouting gaps, tiled and edge surface should slant 20-25mm higher at the door and water should run away to stair, every where on the tiled surface, when completed. Regards Pieter

Review

Workmanship	5.0
Cost	5.0
Schedule	5.0
Communications	5.0

Good job done

Work carried out by the owner/operator
Reviewed on 08-02-2024

Verified Builderscrack review

Job completed by

Kumars building nz limited

Residential Building

Auckland

4.9

Hi , we have been renovating houses for the last 5 years. While we specialise in major renovations we also do smaller jobs from time to time. We are professional and work hard to meet deadlines for project completion and in all areas of customer satisfaction.