Review
Repairing two small holes in gib-board
Job description
Published on 15 September 2024
repairing holes in gib-board 1. ceiling gib-board hole approx 150mm - 200mm diameter cut in error by tradesman. Gib-board circle cut out is suitable to use for repair 2. wall gib-board hole approx 60mm x 120 mm left after removal of heatpump. interior wall repairs only, exterior replairs completed by tradesment involved
Review
| Workmanship |
5.0
|
| Cost |
5.0
|
| Schedule |
5.0
|
| Communications |
5.0
|
Excellent interaction with tradesman who arrived on time and completed job in given time. good workmanship, cleaned up afterwards, would re-engage if I needed a similar job. unable to add photos as such an excellent job that I cannot see where the holes were.
Reviewed on 25 September 2024
