Active job

Concrete Overlay and New Steps

Concrete overlay to closely match existing patio (granite grey) and pour new set of steps to one of the entrances. Front of garage and study entrance steps Photos – “Study Steps”, and “Garage Path Overlay” Approximate measurements - path width 1.8m, length (excl. steps) 10.5m Current steps; top step 1.62m wide, 40cm deep (33cm after lip), 15cm high, bottom step 1.62m wide, 30cm deep, 15cm high What is sought Study steps – lift the step heights to just below the door sill (approx. 6 cm - will need to consider gap at back of step given height of step relative to cladding) and widen the steps to inline with path. Top step 40cm deep, 18cm high, 1.73m wide, bottom step 30cm deep, 18cm high, 1.73m wide Path and steps – overlay with a finish to match the patio on other side of house Front entrance Photo – “Front Entrance” Approximate measurements - width 3m, length 5m, step height 17cm What is sought Path and steps – overlay with a finish to match the patio on other side of house Alternative entrance steps Approximate measurements - current steps; top step top step 51cm deep, 14cm high, 1.55m wide, bottom step 43cm deep, 12cm high, 1.55m wide - there were poured but not 'stamped' at the time What is sought Steps – overlay with a finish to match the patio on other side of house Previous comments from tradesperson who didn't complete the job.... *Materials: 20mpa concrete (steps) tied into house / Overlay / colour wash / activator / acid / sealer *Labour: Remove old steps/box and place new steps,acid wash concrete and apply activator place overlay, scibe, colour wash and seal overlay *Overlay: Remove existing steps and replace with new concrete steps, acid wash all areas, overlay all areas and new steps with granite grey base colour:1/2 black-charcoal colour wash scribed into square pattern, 2 coats of sealer applied