Installation of a Kryptonite Stronghold Surface Anchor 1) Cut a ~19cm x 19cm hole into existing asphalt. Larger can be done if needed. 2) Excavate to 30cm depth. 3) Fill the hole with concrete (minus ~1.5cm). 4) Install the Surface Anchor into/onto the concrete. This may either be performed when the concrete is dried (by drilling 3 holes and installing bolts), or ideally when wet (by installing bolts into anchor, and sliding the installed bolts into the wet concrete. 5) If a larger hole was installed, then it should be filled up around the anchor, and coloured/disguised to be the same colour as the asphalt. 5) Removal of the excavated soil and asphalt. NOTES: Photos attached are a plan with measurements, plus photos of the anchor placed where it should be installed. There are a Chorus cable, and water mains, nearby, but it is believed that none will be shallower than 30cm - excavation of the hole should nonetheless be done carefully. Not urgent - some time in the next month. Awaiting final approval for plan from bodycorp - will need to wait until receive that approval.
Workmanship |
5.0
|
Cost |
5.0
|
Schedule |
5.0
|
Communications |
5.0
|
Excellent. Used high quality/dense concrete when I explained the requirement, and worked around some unexpected installation issues. Excellent job camouflaging the concrete. Turned up when he said he would, and worked with my schedule.
Work carried out by the owner/operator
Reviewed on 05-04-2021
#1 | Tradie 1 | No recent reviews | 10 jobs | Secured job |
#2 | Tradie 2 |
|
7 jobs | No longer in contact |
Partner with Builderscrack
Get work