I need a circular ring made from cheap, flat wood. It will be glued to the wooden back of a circular mirror to create a lip for an LED strip. The ring needs to be 87.5cm in diameter. The width of the ring can be anywhere from 2 - 5cm, but ideally as close to 2cm as possible. The thickness of the wood can be anywhere from 1.5cm to 2cm, but ideally as close to 1.5cm as possible. A small, tapered cut needs to be made into the ring to create a 0.75cm wide opening (for the power connection). Fine for it to be two halves, or three quaters
Workmanship |
5.0
|
Cost |
5.0
|
Schedule |
5.0
|
Communications |
5.0
|
CMVM (Chris) is an excellent, precise and considerate communicator - top notch work, exactly to spec and budget.
Work carried out by the owner/operator
Reviewed on 20-03-2024
Partner with Builderscrack
Get work