Review

Hot Water Cylinder replacement, removal of old cylinder

Job image
Job image
Job image
Job image

Job description

Hot Water Cylinder Plumbing & Installation New Lynn, Waitakere

Published on 18th February 2026

Quote • Drain and remove the existing 135L low pressure hot water cylinder • Supply and install a new 135L low pressure hot water cylinder in the same location, dimensions for new cylinder allowed for: 510mm Diameter, 1140mm High • Supply and install new valves including isolation on water entry to cylinder, pressure reducing valve and 3in1 valve before pressure reducing. 3in1 Valve includes isolation, filter and non return. • Upgrade the outlet of the new hot water cylinder to 20mm then reconnect back onto the 15mm hot branch line and reconnect to the 15mm vent before it enters the ceiling. • Seismically restraint the cylinder in position Please note: The vent pipe is undersized, it should be 20mm and installed vertically with no offsets, not allowance been made to replace the entire vent pipe. No allowance has been made for the supply or installation of a tempering valve. Electrical Estimate • Replace the existing cylinder connection kit for a new one • Wire up the new hot water cylinder • Test and supply electrical certification


Full workmanship review

Workmanship
5.0
Cost
5.0
Schedule
5.0
Communications
5.0

"I would highly recommend Mitchell & definitely would book him again. He turned up on time to both quote & again on the job, his communication was impeccable & he did a great job in the time quoted. He was thorough, tidy & his quote was clearly itemised. He's polite & considerate (not leaving the van on a shared driveway gets bonus points!). He followed up on the same day. He was flexible with payment terms. Honestly could not find a fault. The Sparky who worked with him I'd rate too. Five stars!"

Work carried out by the owner/operator

Review posted by Sarah on 2nd March 2026

Verified Builderscrack review

Get connected now with NZ’s largest trade professional network

Get started