We have this computer desk table- its metal with metal legs - which is too high. We would like to get the legs cut down about 4.5 to 5 cm if that is possible. The legs themselves are uniformly shaped all the way (not tapered at the end or anything), but are finished at the bottom with a little round plastic disk which is a carpet protector and finishes it off. If the legs can be cut down, we are not sure if the finish at the bottom can be put back in place or not. If not, we will leave them off. However, if thats the case we would appreciate if the raw ends of the metal at the bottom of each leg are smoothed off a bit so that they are not too sharp. The two photos attached show the desk itself (messy with stuff on it !) and a close up photo of the end of one of the legs - we lifted it up slightly to try to show the bottom bit. Thanks!
Workmanship |
5.0
|
Cost |
5.0
|
Schedule |
5.0
|
Communications |
5.0
|
Thanks Tick for doing this job for us at such a good price. Very tidy work. Also really appreciated the extra job you did by fixing the power board to the underside of the desk. That was a great suggestion from you. Will definitely contact you again when I have another job.
Work carried out by the owner/operator
Reviewed on 21-12-2021
Partner with Builderscrack
Get work