Published on 23 September 2024
Three story town house, router is on the first floor. I would like Ethernet run through the walls and Ethernet ports installed on the ground floor (garage) and the top floor (two bedrooms). We currently have some external cladding exposed which may make the job easier. Cladding will only be exposed for about a week. I have attached photos roughly detailing what I would like, however I'm open to easier locations of the Ethernet jacks. I imagine that the cable can be fed down into the ground garage - the cable could just be hidden by conduit to the ground jack. Ideally these should be next the power points on each floor. The cable then from the ground could be fed up to the top floor, then hopefully installed next to the power points in each bed room. There is no easy roof access. The bedroom on the back is optional if its too difficult. Ground floor is concrete, first floor is concrete and top floor is not concrete.
Workmanship |
5.0
|
Cost |
5.0
|
Schedule |
5.0
|
Communications |
5.0
|
Work carried out by the owner/operator
Reviewed on 9 October 2024
Partner with Builderscrack
Get work