Review

Two small Maintainance jobs

Job description

General Carpentry
Tauranga

1) To pull up a chip board section to check underfloor joists. This is an old home and the floor cavity falls well below the depth todays average newer homes . The floor is rimu but a section was repülaced with chip board approx 10 yrs ago. We need to have joists & piles checked before we get new floor covering laid as there has been a history of 'dry rot' 2)Remove one walls wallboard ( approx 3 mt wide x 2.5 mt high)and replace with gib board ( preferably a bathroom grade Gib board) this wall suffered from water damage last year


Review

Workmanship
5.0
Cost
5.0
Schedule
5.0
Communications
5.0

Excellent job well done at reasonable cost. Very Happy with result

Work carried out by the owner/operator
Reviewed on 27-11-2016

Tradesperson reply
"This was an Inspection of a downstairs flat in an old Art Deco home very low to the ground. I added ventilation vents where needed to ensure adequate air movement to prevent dry rot in the sub floor framing. I also lowered the outside ground level for drainage as well as removing some Gib to inspect the retaining concrete behind it for moisture getting through. I then rte Gibbed and stopped the area affected. All in 8 hours total time charged."

Verified Builderscrack review

Get connected now with NZ’s largest trade professional network

Get started

As seen on

logo
logo
logo
logo
logo
logo
logo
logo